Flashforge Finder - 3D Printer XX
The next generation of ease to use. An experience unlike any other.
Finder is the easiest-to-use 3D printer so far. It is fully assembled. And now with its assisted leveling system, you just need to do very few tweaks before starting prints. Featured with a 3.5-inch touchscreen panel, filament-run-out detection, USB stick and 2nd Generation Wi-Fi connection and more, Finder delivers you a top-notch user experience that any other 3D printers can not.
Intelligent assisted leveling system.
More precise and easier calibration.
Finder features an intuitive calibration detection system to assist leveling. You are directed to tighten or loosen leveling screws until a beeper barely sounds, then it detects the distance between nozzle and build plate to verify whether your leveling is at the right position. Once the first location is leveled, you’re directed to next two screw locations accordingly with same operation. In this whole process, you’re well instructed with clear messages on the touchscreen display. And all of these make calibration much easier and more precise than before.